Carlton 1712 Manual do Operador descarregar pdf (Página 104)

12” CHIPPER SERVICE

CUTTER SYSTEM

78

• Use the handle on the anvil to rotate the

anvil 90

° and pull it through the slot.

• Remove the handle from the anvil and

turn the anvil to a good working edge.

The working edge that was being used is

on the back opposite side from the

handle.

• Replace the handle either in the same

hole on the other side of the anvil or

remove the setscrew and insert the

handle in the hole on the opposite side of

the anvil. Use LocTite

® Red 262 on the

handle when replacing and torque jam

nut to 25 ft. lbs. (5/16”-18 bolt).

• A setscrew must always be in the hole

next to the working edge to keep debris

out of the hole (see picture at right).

Insert the setscrew on the handle side of

the anvil to prevent clogging the wrench

slot. Use LocTite

® Red 262 on the

setscrew when replacing to keep the

setscrew from working out of hole or

damage will occur because of tight

tolerances.

• Replace with a new anvil if all working

edges are worn or damaged. Do not

grind the anvil to get more life. There is

only a certain amount of adjustment

available for clearance and if the anvil is

ground you will loose that adjustment

capability.

• The anvil is hardened steel made to

Carton’s specifications. Use only

Carlton anvils as replacements or

damage may occur. Purchase the new

anvil from Carlton or an authorized

dealer.

CURRENT WORKING EDGE

HANDLE

INSERT SETSCREW FROM THIS SIDE –

OPPOSITE TO HANDLE

USE LOCTITE® RED 262

REMOVE ANVIL –

ROTATE 90° &

PULL THROUGH

OPENING

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 164 165

Comentários a estes Manuais

Sem comentários