Carlton 1712 Manual do Operador Página 108

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 165
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 107
12” CHIPPER SERVICE
BELTS
82
ENGINE MUST BE OFF AND
IGNITION KEY REMOVED BEFORE
CHECKING BELT TENSION. ALL
PARTS MUST BE COMPLETELY
STOPPED.
Insert a screwdriver or metal bar (a
metal ruler would be good) through the
slot to check belt tension.
Make a mark on the screwdriver or
metal when it touches the belts without
any force applied and then apply force
and make another mark.
Measure the distance between the two
marks. If the measurement is more than
1/2", the belts tension needs to be
adjusted. If the measurement is much
less than 1/2", the belts tension is too
tight.
Do not over tighten the engine belts.
Overly tight belts will cause damage to
PTO/clutch bearings and to cutter disk
bearings.
ADJUST BELT TENSION
Loosen engine slide bolts (four places).
Bolts are secured through a block under
the frame and will require only one
wrench to loosen the 5/8” bolts.
ENGINE SLIDE BOLT
INSIDE JAM NUT
OUTSIDE JAM NUT
Vista de página 107
1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 164 165

Comentários a estes Manuais

Sem comentários