Carlton 1712 Manual do Operador descarregar pdf (Página 85)

12” CHIPPER SERVICE

HYDRAULICS

WARNING:

 RELEASE HYDRAULIC PRESSURE BEFORE PERFORMING ANY SERVICE

TO HYDRAULIC LINES OR OTHER COMPONENTS.

 FLUID UNDER PRESSURE CAN PENETRATE THE SKIN AND CAUSE

SEVERE INJURY. SEEK IMMEDIATE MEDICAL ATTENTION IF SKIN IS

PENETRATED. CHECK HOSES AND FITTINGS USING A BOARD OR

CARDBOARD; DO NOT USE HAND OR FINGER. ALWAYS WEAR EYE

PROTECTION.

HYDRAULIC OIL & FILTER

• This Carlton chipper has an in-tank

hydraulic filter and a level/temp gauge.

Check hydraulic oil daily, before and

during use. Refill with AW-32

hydraulic oil, same as supplied by the

manufacturer.

• Carlton chippers are equipped with

lockable cap guards.

DO NOT PERFORM MAINTENANCE OF ANY KIND ON THIS MACHINE UNLESS:

 The engine is turned off

 The ignition key has been removed

 The positive battery cable has been disconnected

 The clutch is disengaged

 Feed control bar is in neutral

 All machine parts have come to a complete stop – NOTE: The cutter disk takes

several minutes to come to a complete stop

 All machine parts have had sufficient time to cool down

 The cutter disk lock pin is installed in the disk lock tube

 No operator is in position at the controls to accidentally start machine

 At least 2 people are at the site where maintenance is performed

More accidents occur while performing maintenance than any other time! Use extra

caution.

Never perform maintenance with the engine running, not even with the clutch disengaged.

The pilot bearing could seize or freeze to the clutch shaft and permit the clutch to engage

even though the operator thought the clutch had been disengaged.

ALWAYS REPLACE GUARDS AND OTHER PROTECTIVE EQUIPMENT BEFORE

STARTING CHIPPER AFTER PERFORMING MAINTENANCE.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 164 165

Sem comentários

Carlton 1712 Manual do Operador Página 85