Carlton 1712 Manual do Operador descarregar pdf (Página 110)

12” CHIPPER SERVICE

BELTS

REPLACING BELTS

• Replace belts when they are worn or

regularly need adjustment.

• Replace belts as a complete set. Old or

worn belts will not tension the same as

new belts.

• Remove belt guard bolts and remove belt

guard.

• Loosen all four engine slide bolts.

• Loosen outside jam nuts (two places)

and turn inside jam nuts counter-

clockwise to move engine back and

loosen belts enough to remove over

sheaves. Clutch should be disengaged.

• Jam nuts will only need to be turned a

few turns to loosen belts.

• Cutter disk lock pin should be removed

to allow the sheaves to turn in removing

the belts. DO NOT HAVE CUTTER

DISK HOOD OPEN.

• Remove all four belts. It may be a good

idea to start removing 2 belts from each

sheave as shown in the pictures to the

right.

• Install new belts using the same

procedure only in reverse.

• Never pry new belts onto the sheave!

OUTSIDE JAM

NUTS

INSIDE JAM

NUTS

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 164 165

Sem comentários

Carlton 1712 Manual do Operador Página 110