Carlton 1712 Manual do Operador descarregar pdf (Página 82)

12” CHIPPER TROUBLESHOOTING GUIDE

DO NOT PERFORM ANY INSPECTION OR SERVICE ON THE CHIPPER WITHOUT

MAKING SURE: THE CUTTER DISK IS DISENGAGED AND HAS COME TO A

COMPLETE STOP; THE CUTTER DISK LOCK PIN IS INSTALLED; THE ENGINE

HAS BEEN TURNED OFF, THE IGNITION KEY HAS BEEN REMOVED AND THE

BATTERY CABLE HAS BEEN DISCONNECTED; THE FEED WHEELS HAVE BEEN

RAISED, THE YOKE LOCK PIN IS IN POSITION, AND THE WHEELS HAVE BEEN

BLOCKED; AND THERE ARE AT LEAST TWO OPERATORS AT THE SITE.

FOLLOW PROPER MAINTENANCE PROCEDURES IN SERVICE SECTIONS

TO REPAIR OR REPLACE PARTS OR CONTACT YOUR DEALER.

COMPLAINT CAUSE CORRECTION

Discharged chips are not

correct size: too large or too

fine

• Knives have lost their edge

• Knife anvil worn

• Check for wear in the

throat/base area (non-cutting

areas)

• Knife angle is not correct

• Material being chipped is

very small, dry or rotting

• DO NOT operate chipper

with dull knives or with

mismatched knives (see

Servicing Cutter System

section)

• Rotate, repair, or replace (see

Servicing Cutter System

section)

• Outer, non-cutting edges that

are exposed to chipper

knives must be built up with

weld to maintain surface to

original integrity

• Make sure knives are ground

at correct angle (see

Servicing Cutter System

section)

• This type of material does

not produce good chip

quality

Cutter disk knife hits anvil • Anvil to knife clearance is

not correct

• Check the chipper bearing

retainer cap for tightness

• See Servicing Cutter System

section for adjustment

• Retighten bolts or setscrews

as tight as possible

Discharge chute clogs or chips

are not discharging properly

• Lugging engine on large

material

• Obstruction in discharge

chute

• Chipping rotting material

that has little substance can

also plug the discharge chute

• Keep engine speed up and

use feed control bar to

reverse material if engine

lugs down

• Any object that protrudes

inside the chute may cause

clogging; replace discharge

chute, if necessary

• Use care when running this

type of material; “flush” the

discharge chute with

material that has more

substance

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 164 165

Comentários a estes Manuais

Sem comentários

Carlton 1712 Manual do Operador Página 82

Comentários a estes Manuais

Manuais e produtos relacionados com Trituradores de jardim Carlton 1712