Carlton 2518 Manual do Operador descarregar pdf (Página 100)

18” DRUM SERVICE

CUTTER SYSTEM

• Reassemble knives in the pocket making

sure they seat flat.

• Tighten knife bolts (3/4”-10) and nuts.

Torque to 235 ft. lbs.

• Do not over tighten knife bolts. Torque

only to the recommended amount.

Knives that are overly tight can crack or

bow around the hole. This could cause

chipped material to pack between the

knife and cutter drum causing knife

failure. Check knife for distortion using

a straight edge and a light, replace the

knife if distorted.

CHECK/ADJUST CLEARANCE

ALWAYS CHECK AND SET KNIFE TO

ANVIL CLEARANCE AFTER

REMOVING AND REPLACING

KNIVES OR ANVIL.

• Raise and block upper feed wheel. Use

the hydraulic lift to raise the upper feed

wheel. Insert the yoke lock pin into the

yoke lock tube.

• Place a block of wood 4” x 18” x 16”

between the feed wheels.

• Inspect the anvil working edge for wear

or damage before you check the

clearance. If the anvil needs to be

changed to a new work surface or to be

replaced, follow the instructions in Anvil

Replacement later in this section. The

anvil has four working edges that can be

used before replacing.

ANVIL WORKING EDGE

FEED WHEEL RAISED &

LOCK PIN INSERTED

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 198 199

Sem comentários

Carlton 2518 Manual do Operador Página 100