Carlton 2518 Manual do Operador descarregar pdf (Página 106)

18” DRUM SERVICE

CUTTER SYSTEM

79

• The angle support for the bolts will also

come off when the anvil bolts are

removed. Keep all parts together to

reassemble later. Inspect all parts and

replace any that are damaged.

• The working edge of the anvil is the top

edge closest to the drum. Use gloves

and be careful when lifting the anvil, as

the edges are very sharp. Lift the anvil

out of the pocket and inspect the other

working edge. If the other edge is still

good, flip the anvil over and put it back

in the pocket. Make sure the sharp edge

is on top and toward the drum.

• The edge of the anvil can be ground to

get more use. The angle on the end of

the anvil is 59°; maintain this angle

when grinding. DO NOT grind the anvil

to the point that all the adjustment

capability is gone, replace with a new

anvil. DO NOT grind more than 1/8”

per side.

• The anvil is hardened steel made to

Carton’s specifications. Use only

Carlton anvils as replacements or

damage may occur. Purchase the new

anvil from Carlton or an authorized

dealer.

• When the anvil has been replaced,

replace the angle and the bolts that were

removed earlier. Be sure to replace the

lock washers closest to the head of the

hex bolts and the flat washers next.

• Screw in the four short bolts first in the

positions shown at the right. Leave the

anvil bolts slightly loose to adjust the

clearance.

KEEP ANGLE, BOLTS, AND WASHERS TOGETHER

SCREW THE FOUR SHORT BOLTS IN FIRST

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 198 199

Comentários a estes Manuais

Sem comentários