Carlton 2518 Manual do Operador descarregar pdf (Página 62)

18” DRUM MACHINE OPERATION

• Start engine at idle and allow sufficient

time for oil to circulate before

proceeding. A two-position switch is

located next to the key switch in the

control panel. The lower (idle) position

is for starting the engine, low speed

engine operation during warm up, clutch

engagement/disengagement, and engine

cool down. The upper position is for

running the engine at full speed during

chipping operations. (See engine manual

for further starting procedures. Be sure

to follow the engine manual instructions

for cold weather operation.)

• Test the controls for proper operation,

especially the feed control bar. (The

engine speed must be high enough for

the Auto-Feed® to engage the

hydraulics or the Auto-Feed® must be

off. Press down the left button and hold

for 4 seconds to turn Auto-Feed® off.)

− Push feed control bar to the rear of

the machine to test forward (pulling)

feed wheel motion

− Pull feed control bar to the middle

position to test off position (feed

wheels should not turn at all)

− Pull feed control bar all the way

toward the front of the machine to

test the reverse feed wheel motion

THROTTLE SWITCH – LOW (IDLE)

THROTTLE SWITCH -HIGH

FEED CONTROL - FORWARD

FEED CONTROL - REVERSE

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 198 199

Sem comentários

Carlton 2518 Manual do Operador Página 62