Carlton 2518 Manual do Operador descarregar pdf (Página 192)

Axles equipped with Dexter's E-Z Lube feature can be periodically lubricated without removing

the hubs from the axle. This feature consists of axle spindles that have been specially drilled and

assembled with grease fittings in their ends. When grease is pumped into the fitting, it is

channeled to the inner bearing and then flows back to the outer bearing and eventually back out

the grease cap hole.

1. Remove the rubber plug from the end of the grease cap.

2. Place a standard grease gun onto the grease fitting located in the end of the

spindle. Make sure the grease gun nozzle is fully engaged on the fitting.

3. Pump grease into the grease fitting. The old, displaced grease will begin to flow

back out the cap around the grease gun nozzle.

4. When the new, clean grease is observed, remove the grease gun, wipe off any

excess, and replace the rubber plug in the cap.

The E-Z Lube feature is designed to allow immersion in water. Axles not equipped with E-Z

Lube are not designed for immersion and bearings should be repacked after each immersion. If

hubs are removed from an axle with an E-Z Lube feature, it is imperative that the seals be

replaced before bearing lubrication. Otherwise, the chance of grease getting on brake linings is

greatly increased.

NOTE: The convenient lubrication provisions of the E-Z Lube must not replace periodic inspection of the

bearings.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 198 199

Sem comentários

Carlton 2518 Manual do Operador Página 192