Carlton 2518 Manual do Operador descarregar pdf (Página 61)

18” DRUM MACHINE OPERATION

34

• Carlton Chippers are equipped with a

height adjustable discharge chute. This

allows the discharge chute to be adjusted

for different truck heights and discharge

angles.

• To adjust discharge chute height:

− Flip retainer up out of the way of the

crank handle

− Crank height adjuster to adjust chute

to desired height

− Return retainer to original position

securing crank handle

NEVER ADJUST THE DISCHARGE CHUTE

WHILE CHIPPER IS IN OPERATION OR

WHILE THE CUTTER DRUM IS SPINNING

CHECK THE INFEED TRAY

• The infeed tray on the 18” chipper is

fixed in the open position. Check to

make sure there isn’t any material or

other objects anywhere in the infeed tray

before starting the chipper.

START ENGINE

• Key Switch and Gauges are located in a

lockable panel at the rear of the engine.

• The engine is supplied with a three-position

key switch. Turn the key clockwise all the

way to start the engine; always start the

engine at idle. When the engine is running,

release the key and it returns to the on (run)

position. Turn the key counter-clockwise to

shut down the engine.

DO NOT OPERATE THE ENGINE AT

AN ANGLE GREATER THAN 25° OR

SEVERE ENGINE DAMAGE WILL

OCCUR. PROPER ENGINE OIL LEVEL

MUST BE MAINTAINED TO ACHIEVE

MAXIMUM ANGLE OF OPERATION OF

25°. (See Engine Owner’s Manual for

proper oil level.)

CONTROLS MAY VARY DEPENDING ON

ENGINE OPTION

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 198 199

Comentários a estes Manuais

Sem comentários