Carlton 2518 Manual do Operador descarregar pdf (Página 86)

18” DRUM TROUBLESHOOTING GUIDE

DO NOT PERFORM ANY INSPECTION OR SERVICE ON THE CHIPPER WITHOUT

MAKING SURE: THE CUTTER DRUM IS DISENGAGED AND HAS COME TO A

COMPLETE STOP; THE CUTTER DRUM LOCK PIN IS INSTALLED; THE ENGINE

HAS BEEN TURNED OFF, THE IGNITION KEY HAS BEEN REMOVED AND THE

BATTERY CABLE HAS BEEN DISCONNECTED; THE FEED WHEELS HAVE BEEN

RAISED, THE YOKE LOCK PIN IS IN POSITION, AND THE WHEELS HAVE BEEN

BLOCKED; AND THERE ARE AT LEAST TWO OPERATORS AT THE SITE.

FOLLOW PROPER MAINTENANCE PROCEDURES IN SERVICE SECTIONS

TO REPAIR OR REPLACE PARTS OR CONTACT YOUR DEALER.

COMPLAINT CAUSE CORRECTION

Discharged chips are not

correct size: too large or too

fine

• Knives have lost their edge

• Knife anvil worn

• Check for wear in the

throat/base area (non-cutting

areas)

• Knife angle is not correct

• Material being chipped is

very small, dry or rotting

• DO NOT operate chipper

with dull knives or with

mismatched knives (see

Servicing Cutter System

section)

• Rotate, repair, or replace (see

Servicing Cutter System

section)

• Outer, non-cutting edges that

are exposed to chipper

knives must be built up with

weld to maintain surface to

original integrity

• Make sure knives are ground

at correct angle (see

Servicing Cutter System

section)

• This type of material does

not produce good chip

quality

Cutter drum knife hits anvil • Anvil to knife clearance is

not correct

• See Servicing Cutter System

section for adjustment

Discharge chute clogs or chips

are not discharging properly

• Lugging engine on large

material

• Obstruction in discharge

chute

• Chipping rotting material

that has little substance can

also plug the discharge chute

• Keep engine speed up and

use feed control bar to

reverse material if engine

lugs down, check Auto-Feed

Plus setting and adjust (see

Auto-Feed Plus Manual)

• Any object that protrudes

inside the chute may cause

clogging; replace discharge

chute, if necessary

• Open air vents on sides of

chipper drum

• Use care when running this

type of material; “flush” the

discharge chute using other

material with more substance

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 198 199

Comentários a estes Manuais

Sem comentários

Carlton 2518 Manual do Operador Página 86

Comentários a estes Manuais