Carlton 2518 Manual do Operador descarregar pdf (Página 113)

18” DRUM SERVICE

V-BELT

• Install the new belt using the same

procedure only in reverse. Put the belt

on the cutter drum sheave first and then

the engine sheave.

• Never pry the new belt onto the sheave!

Move the engine back further if needed.

• Once the belt has been replaced, you will

need to loosen the inside jam nuts and

tighten the outside jam nuts on the

eyebolts.

• When the belt starts getting tight, check

tension. (See Check Belt Tension and

Adjust Belt Tension earlier in this

section.)

• Check sheave alignment and make

adjustments using engine slide

adjustment (jam) nuts. Make slight

adjustments until sheaves are aligned

and tension is correct.

• When tension is correct, retighten the

engine slide bolts at the rear of the

engine first.

• Then, loosen the outside jam nuts and

tighten the front engine slide bolts. If

you don’t loosen the outside jam nuts

before tightening the front engine slide

bolts, the eyebolt will be at an angle.

This will cause the threads on the

eyebolt to be damaged.

• Retighten both jam nuts on each eyebolt.

Tighten the outside jam nut on each

eyebolt first and then the inside jam nuts.

• Then torque all four engine slide bolts

(3/4”) to 175 ft lbs.

ENGINE SLIDE

BOLTS REAR

ENGINE SLIDE

BOLTS FRONT

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 198 199

Sem comentários

Carlton 2518 Manual do Operador Página 113