Carlton 2518 Manual do Operador descarregar pdf (Página 107)

18” DRUM SERVICE

CUTTER SYSTEM

• Replace the two eyebolts on each end of

the anvil. Put the eyebolts on the two

long bolts after the washers are on.

• The adjuster eyebolts must be inserted

through the slot provided to make

clearance adjustments. A flat washer

goes between the nut on the adjuster bolt

and the plate.

• Leave the anvil bolts slightly loose to

adjust the clearance. Put a flat washer

and a nut back on the outside of each

adjuster bolt. Do not tighten the nut

until clearance has been set.

• ALWAYS CHECK & SET KNIFE TO

ANVIL CLEARANCE AFTER

REMOVING AND REPLACING

KNIVES OR ANVIL.

• Go back to the Check/Adjust Clearance

earlier in this section.

• After the clearance has been set, tighten

the anvil bolts (1/2”-13) and torque to

75 ft. lbs.

• Either the outside or the inside nuts will

be tight after adjusting the clearance.

Tighten the nuts on the adjuster bolts

that are still loose.

• ALWAYS REMEMBER TO CLOSE

THE CUTTER DRUM DOOR

AFTER SERVICING CUTTER

DRUM.

• INSTALL THE DOOR LOCK PIN

AND PADLOCK.

• Check condition of cutter drum door.

Make sure the hinges are not damaged

and that the door closes completely with

no gaps or openings; check both sides.

If there are any problems go to Servicing

Cutter Drum Door later in this section.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 198 199

Sem comentários

Carlton 2518 Manual do Operador Página 107